Wire Mesh Galvanised for Solar Panel Pigeon Proofing Weld Mesh 30m

Description

Galvanized wire mesh, also known as welded mesh, is an excellent choice for pigeon proofing around solar panels. It is made from high quality, hot dipped galvanized steel wire that has been specially treated to ensure strength and durability.

The mesh has a hole size of 12.00 mm x 12.00 mm and is 200 mm wide and 30 meters in length, making it easy to cut or bend to fit any size solar panel.

The mesh is suitable for deterring all types of birds, including pigeons, sparrows, and starlings, from nesting or roosting under your solar panels. When properly installed, it will effectively keep pests away and help protect your investment in solar energy.

In addition to its strength and versatility, this galvanized wire mesh is also easy to install. It can be attached to the underside of your solar panels using screws, staples, or other suitable fasteners. With proper installation, it will provide long-lasting protection against pests and help keep your solar panels functioning at their best.

Overall, this roll of galvanized wire mesh is an effective and affordable solution for pigeon proofing your solar panels and protecting your investment in renewable energy.

Installation guidance

Solar panel pigeon proofing wire mesh is an effective solution for protecting your rooftop solar panel arrays from birds.

The solar panel pigeon proofing wire or weld mesh is supplied in rolls and can be cut into six-foot lengths for easy handling.

To install the solar panel pigeon proofing wire or weld mesh, you will need to straighten it out and then use a length of 2 X 4 timber to bend the bottom inch of the solar panel pigeon proofing wire or weld mesh at a 30-degree angle. This helps to lock the solar panel pigeon proofing wire or weld mesh into place and prevent birds from getting under the solar panels.

To install the solar panel pigeon proofing wire or weld mesh on your solar panels pigeon proofing clips, you will need to use patent-pending clips. These solar panel wire mesh pigeon proofing clips hold the wire mesh securely in place without causing any damage to the solar panels or voiding any warranties.

You should use three solar panel wire mesh pigeon proofing clips on each long edge of the solar panel and two clips on each short edge, as shown in the attached diagram. This will ensure that the mesh is held firmly in place and provides maximum protection against bird damage.

This non-penetrating system is easy to install and can be removed for servicing if needed. It is suitable for all types of birds and can be used in any location where solar panels are installed. Whether you are dealing with high or low levels of bird pressure, this solar panel pigeon proofing wire mesh is an effective and affordable solution for protecting your investment in renewable energy.

See the diagram attached to this product listing for more details and an example of a typical installation.

• Where to Use solar panel pigeon proofing wire mesh : Rooftop solar panel arrays
• Target Bird: All species
• Bird Pressure: All levels
• Installation: Wire mesh is bound to solar panels using patent-pending clips